16
SETTING
DESCRIPTION
Device IP
View the IP address to configure wireless connection (only if a Wi-Fi network is configured).
WIFI CONFIG
Wireless control configuration (see the next page).
MTZ mode
External temperature module configuration (read the manual included with the module).
Lock the device
Control panel lock. Enable by pressing
–
in the menu. To disable, press and hold
START
/
STOP
for 5 seconds.
Child lock
Child lock
– flame ignition is initiated by pressing
START
/
STOP
for 3 seconds. Choose
ON
/
OFF
to enable/disable the function.
Set time
Set the hour by pressing
+
, next press
–
and set minutes. Accept with
–
.
Remote Control
Programming a new remote or connecting one remote with multiple devices. Press
–
to start
the configuration. Press and hold
START
,
STOP
,
+
,
–
for 1 second, respectively. Message
PROGRAMMING FINISHED
informs that the configuration has been successfully completed.
Display off
If inactive for 1 minute, the display will turn off. Choose
ON
/
OFF
to enable or disable the option.
Fast start
Faster flame ignition (enabled by default). The power consumption is 100W higher when
the device is ready for flame ignition. Choose
OFF
to disable.
Serial number
View the device serial number.
Software
View the software version.
History
View 40 recent messages.
WIRELESS CONTROL CONFIGURATION
1.
To start the configuration, select
Wi-Fi CONFIG
in the menu. Time to finish the configuration is 5 minutes.
2.
Enable Wi-Fi connection in your mobile device and connect to
planika123
network (if the network is not visible on the list,
disconnect the power supply from the device for 10 seconds and start the configuration again).
3.
Start the application on your mobile device. The fireplace will be appear in the Manager window.
4.
Connect to the fireplace and go to
SETTINGS
. Choose the connection mode (
MODE)
and security protocol (
SECURITY
).
Enter the network name (
SSID_NAME
) and password (
PASSWORD
).
5.
If static IP is required, enter IP ADDRESS, NETMASK and GATEWAY. For dynamic IP enable DHCP. Accept the settings
by pressing
submit
.
6.
Connect to the selected/created network in the Wi-Fi menu in your mobile device.
7.
The application will automatically search for the fireplace.
ERRORS
The errors are accompanied by a sound signal. Press
START/STOP
to mute or turn the device OFF by pressing
.
ERROR
SOLUTION
(contact the Service Department if the solution does not eliminate the error)
TEMPERATURE TOO HIGH
Wait for
READY
.
EN
GL
ISH
MODE
OFF
Blocks wireless control
via Wi-Fi.
STA
Connection with via your local network and
a router
AP
Direct connection between the device
and your mobile device (outside your
local network)
SECURITY
--
Choose the security protocol used in your
local network
(usually
WPA
/
WPA2
).
Choose security protocol
WPA
(recommended) or
WEP
.
SSID_NAME
--
Enter the name of your local network.
Create a network name.
PASSWORD
--
Enter your local network password.
Create a network password
(min. 8 characters).
