12
INSTALLATION AND OPERATION – CONTINUED
PLACING A CALL
With your headset in position, place the handset off-hook.
Press the Talk Button on either the Remote
(2)
or the Base Unit.
(18)
The In Use Indicator Lights
(1)(14)
on the Remote and Base Unit will light and you
will hear a dial tone
If you do not hear a dial tone, see Troubleshooting on page x.
Dial a co-worker. When your answers, speak normally.
If your co-worker cannot hear you or you hear a buzz or hum, move the
Configuration Switch to another setting.
Adjust how loud you sound to your co-worker by adjusting the Talk Volume Control.
(16)
Adjust the volume of your co-workers voice by using the Listen Volume
Control
. (10)
Replace the handset upon completion of the call and press either Talk button on the
Remote
(2)
or the Base Unit
(18)
for two seconds. The In Use Indicator Lights
(1)(14)
will go out.
G
D
F
E
D
RECEIVING A CALL
With your headset in position, when your telephone notifies you of an incoming call,
place the handset off-hook.
Press the Talk Button on the Remote
(2)
or the Base Unit
(18)
The In Use Indicator
Lights
(1)(14)
will go on. Begin speaking.
Replace the handset upon completion of the call and press the Talk Button on the
Remote
(2)
or the Base Unit
(18)
for two seconds. This In Use Indicator Lights
(1)
(14)
will go out.
D
D
PAGE FUNCTION
If you have mislaid the Remote Unit or someone at the Base Unit needs to locate you,
pressing the Page Button
(17)
causes the Remote to emit a long, loud beep.
C
