PLASMON LMS - LD 8100 USER MANUAL
Page 36
Ensure the installation site is able to support a volumetric air flow of 3.2 m
3
/min (112 cfm). Also ensure that
the operating environment is free from dust and particulates, such as tobacco smoke.
WARNING
To prevent fire or shock hazard, do not expose the LD 8100 to rain or
moisture. Refer servicing to qualified technicians. In case of fire or
other emergency, isolate the units from the main power by
disconnecting the power plugs from their site power receptacles. In
situations where disconnecting the plugs is not possible or practical,
use the system main power disconnect to isolate the unit from the
main power. Use of controls or adjustments, or performance of
procedures other than those specified herein may result in exposure
to hazardous laser radiation. Do not stare directly into the laser beam
or its reflection on any reflecting mirror-like surface. Visible laser
radiation can be emitted if the unit is opened.
QUICK RELEASE RACK MOUNT KIT INSTALLATION
This procedure provides the instructions for installing an LD 8100 into a standard EIA 19-in. rack. Before
the LD 8100 is installed, ensure that the site installation requirements are met (refer to the Installation
Requirements section in this manual). The Desktop, Tower, FileNet Library and Plasmon Library
configurations are shipped with the appropriate enclosure and hardware installed; the Mounting Kit for the
Rack Mount configuration must be installed in the field.A minimum of 116 cm (46 in.) is required at the front
of the rack during installation and to fully extend the LD 8100 on the slides.
WARNING
Installing the LD 8100 into a rack requires two people to lift the drive
into mounting position. After the LD 8100 is installed in the rack, the
drive must be properly grounded to avoid exposing personnel to
electric shock during operation.
The Quick Release Rack Mount Kit consists of the following:
•
one left Slide Assembly
•
one right Slide Assembly
•
four Mounting Brackets
•
six M4 x 6 screws
•
eight M4 X 8 screws
•
eight M4 nuts
Summary of Contents for LD 8100
