97662915 B
Page 51
3) If the LD 8100 is not the last unit in the daisy chain, plug one end of the other cable into the
vacant connector on the LD 8100 and then connect the other end of the cable to the next
SCSI device. Repeat this process until you reach the last SCSI device in the daisy chain.
If the LD 8100 is the last unit in the daisy chain, install a terminator on the LD 8100's vacant SCSI
connector.
4) Ensure that the SCSI bus is also terminated at the host adapter end.
The SCSI bus must be terminated at both ends in accordance with the LD 8100/LF 8120/LF 8600/LF 8602
SCSI Interface Specification (P/N 97662164).
Figure 32. Multiple LD 8100 SCSI Interface Cable Connections
CONNECTING A SINGLE DEVICE
To install a SCSI interface cable for a single-device configuration:
1) Plug one end of the SCSI interface cable into the vacant SCSI interface connector on the
host.
2) Plug the other end of the interface cable into a SCSI I/O connector on the LD 8100 rear
panel.
3) Ensure that the SCSI bus is terminated at the LD 8100 and the host adapter end (see next
figure).
The SCSI bus must be terminated at both ends in accordance with the LD 8100/LF 8120/LF 8600/LF 8602
SCSI Interface Specification (P/N 97662164).
IN FROM PREVIOUS
SCSI DEVICE
OUT TO NEXT
SCSI DEVICE
Summary of Contents for LD 8100
