PLASMON LMS - LD 8100 USER MANUAL
Page 54
NOTE
Throughout this section, display messages are shown in English, the
default language. However, Operating mode messages can appear in
French or German (refer to the Operating mode section).
Configuration messages will always appear in English.
POWER-ON PROCEDURE
The LD 8100 is powered on with the AC Power Switch located on the rear panel.
The ON position is indicated by a (I) and the OFF position is indicated by a (O) as illustrated in the next
figure.
NOTE
After you turn the drive's power off, wait 5 sec before turning the
power on again.
Figure 35. AC Power Switch Positions
Perform the following procedure to power on the LD 8100:
1) Ensure that the LD 8100 is properly connected (see the Connecting Power and SCSI
Cables and the Connector Verification sections in this manual).
2) Set the AC Power Switch to the ON (I) position and verify that air is flowing through the
LD 8100.
3) Verify that the WRITE PROTECT indicator is illuminated briefly.
4) Verify that the "Selftest" message displayed on the DOC is replaced by the "Insert Disk"
message. This indicates that the power-on selftests have completed without
encountering any errors or faults.
If the "Wrt Prot" configuration is already enabled, the WRITE PROTECT indicator will
also be illuminated.
AC POWER OFF ( O )
AC POWER ON ( I )
Summary of Contents for LD 8100
