97662915 B
Page 71
SETTING THE
MODSEL
RA OPTION
ModSel RA setting determines if the Drive will acknowledge a Mode Select from the host that changes the
state of the Read Ahead. When disabled, the Drive will ignore a MODSEL RA send over SCSI.
Perform the following procedure to enable or disable the ModSel RA option:
1) Enter the Configuration mode by pressing both the LOAD/MENU and TEST/SELECT
switches simultaneously.
2) Press the MENU switch until "Set Config" is displayed.
3) Press the SELECT switch to enter the Set Configuration menu.
4) Press the MENU switch until "ModSelRA:" is displayed.
5) Press the SELECT switch to scroll through the states for the load switch (on, off). When
the desired state is displayed, press MENU to enter the state and move to the next
option in the Set Configuration menu.
6) Simultaneously press the LOAD/MENU and TEST/SELECT switches to move up to the
main menu. Simultaneously press the LOAD/MENU and TEST/SELECT switches again
to exit Configuration mode.
SETTING THE MM
S
PIN
U
P OPTION
When enabled, the (Media Management Spin Up) MM SpinUp option allows the LaserDrive to read
necessary media management information during spin up. If not enabled, the media management
information will be recovered on the first media access command.
Perform the following procedure to enable or disable the MM SpinUp option:
1) Enter the Configuration mode by pressing both the LOAD/MENU and TEST/SELECT
switches simultaneously.
2) Press the MENU switch until "Set Config" is displayed.
3) Press the SELECT switch to enter the Set Configuration menu.
4) Press the MENU switch until "MMSpinUp:" is displayed.
5) Press the SELECT switch to scroll through the states for the load switch (off, on). When
the desired state is displayed, press MENU to enter the state and move to the next
option in the Set Configuration menu.
6) Simultaneously press the LOAD/MENU and TEST/SELECT switches to move up to the
main menu. Simultaneously press the LOAD/MENU and TEST/SELECT switches again
to exit Configuration mode.
Summary of Contents for LD 8100
