97662915 B
Page 99
Zwei Personen werden zum Anheben des LD 8100 benötigt. Der
Versuch, den LD 8100 ohne Hilfe einer zweiten Person zu heben,
kann zu Personenverletzungen führen.
hinweis
HINWEIS
Die interne Länge des SCSI-Kabels beträgt für jeden LD 8100 etwa
340 mm. Dieser Abstand muß als Teil der SCSI-Gesamtkabellänge
berücksichtigt werden.
ANSCHLUß DES NETZKABELS
So schließen Sie das Netzkabel an den LD 8100 an:
1) Stellen Sie sicher, daß ein Wechselstromkabel zur Installation bereitliegt. Die Art des zu
installierenden Wechselstromkabels hängt von der Einbaustelle ab.
VORSICHT
Der LD 8100 muß an ein Stromverteilersystem angeschlossen sein,
das eine direkte Verbindung zur Erdung hat (Netzwerk mit
abgeschlossener Erde (TT, Terminated Terra)/geerdet). Diese Einheit
ist nicht zur Nutzung auf einer erdfreien Masse (Netzwerk mit
unterbrochener Erde (IT, Interrupted Terra)) geeignet.
2) Überprüfen Sie, ob die Stromversorgung eingeschaltet ist und der Stecker des
Wechselstromkabels in die Wechselstromsteckdose am Aufstellort paßt.
3) Überprüfen Sie, ob der Wechselstromschalter an der Geräterückseite des LD 8100
ausgeschaltet (OFF - O) ist.
4) Stecken Sie den Buchsenstecker des Wechselstromkabels in die Wechselstromsteckdose
an der Geräterückseite des LD 8100.
5) Stecken Sie den Stecker des Wechselstromkabels in die Steckdose.
1) Entfernen Sie den Frontblendensatz, indem Sie ihn an beiden Seiten festhalten und nach
oben weg vom Gehäuse ziehen.
Summary of Contents for LD 8100
