9
• Locate the wooden ladder treads and wooden
ladder sides.
[See Figure B16]
• The stretched pools have 4 ladder treads.
• From the fixings kit locate the sixteen x 5mm x
70mm screws used to secure the ladder treads to
the ladder sides.
• Using a 4mm drill bit make holes through the
ladder sides to accept the screws, two holes in
each slot.
[See Figures B17 & B18]
• Place one ladder side on a flat surface with slots
facing upwards. You may wish to protect the wood
surface by padding it with cardboard or similar.
[See Figure B19]
• Fit each ladder tread into a slot and tap home. Do
not hit the ladder sides or treads directly but use a
wooden block.
• Place the second ladder side over the top and tap
home so the treads are firmly in place.
[See Figure
B19]
• Fit two screws through the ladder side into each
tread using the holes drilled earlier.
• Turn the ladder over and fit the remaining screws.
• The ladder is not connected to the pool now but is
needed to check the Top Shelving support
spacings later.
Build the External Wooden Ladder
Figure B16
Figure B18
Figure B19
Figure B17
