18
• Take the remaining screws and using the premade
screw holes in the faceplate as a guide pierce the
liner with them and tighten to just tension the liner
all around.
[See Figure C21]
• Use a sharp stanley knife or simular to cut out the
inner circle of liner material that is outlined by the
cone of the faceplate.
[See Figure C22]
• Tighten the screws evenly so that the faceplate is
flat against the liner forming a water proof seal.
• Screw in the low suction grille faceplate. Do not
over tighten this.
• Repeat this procedure for the return.
[See Figure
C24]
• Use the same method for the skimmer and
optional light but note that these fittings often
come with a second gasket which is fitted between
the liner and faceplate, e.g. on these fittings there
is a gasket either side of the liner
Figure C21
Figure C24
Figure C22
