7
6
2.3 Installing the hot tub and stove
Remove the pallet from beneath the hot tub.
Do not lift the barrel from the top rim!
Install the hot tub and stove on a stable foundation.
Following the instructions, connect the stove with the hoses of the barrel using
the hose clamps included. If the stove is installed incorrectly, water might remain
in the stove or hoses after use. When the water freezes it might damage the
stove.
Install the chimney and its heat shield (optional equipment).
We recommend that you install a hose for wastewater (non-standard equipment)
to lead the water to a suitable outlet further away from the barrel.
The hot tub and stove must be installed on the same level.
A poorly installed hot tub might pose a safety risk.
Using the hot tub
3.1 Preparations
Put the bottom plug of the barrel and the emptying plug
on the front of the stove in place.
Make sure that the stove is level. Fill the barrel with clean water reaching at least
15 cm above the upper hose coupling before lighting the stove.
This way, you make sure that the water is circulating properly in the stove and
that the stove is not damaged. If there is ice in the hose in winter, make sure
that the water is circulating in the stove before lighting it! If there is frozen water
in the stove or pipes, you must not light the stove until you have made sure
the water is circulating. Otherwise the stove might build up pressure which might
cause serious personal injury.
If there are many bathing at the same time, do not fill the barrel to the top
as a lot of water will then flow over the edge. Heating excess water takes longer
and consumes unnecessary energy.
If you are using chemicals (optional equipment) in the bath water read
the manual and the instructions on the package carefully. Overdoses might cause
corrosion of the barrel or stove parts. Do not allow the chemical solution to soak
in the tub for too long and rinse the hot tub thoroughly after use.
Chemicals must never be dispensed manually while people are bathing
in the tub. Always follow the instructions on the package, where to drain
the bath water when using chemicals.”
If you are using another water source than domestic water, check with local aut
-
horities that the quality of the bathing water is high enough. (Directive 2006/7/EY
minimum requirements for bathing water quality). When using natural water of
bathing water quality (not drinking water) without chemicals, do not bathe longer
than an hour. Heating the water must not last longer than 2 hours to
avoid unwanted bacteria. In order to heat the water fast enough, use the lid.
Never light the stove before the barrel is filled with water at
least by 15 cm above the upper hose coupling
PW-SPA Hot tubs
* Depending on a model.
The upper hose must rise upwards
towards the barrel.
The lower hose must fall downwards
towards the barrel.
