www.dero.com | 1-888-337-6729
© 2018 Dero
ULTRA SPACE SAVER SQUARED
Installation Instructions – Wall Mount
Wall
Bracket
Washer
Nut
Lay out parts on the floor where unit is to be
installed and be sure you have all necessary
parts.
Place first wall bracket on wall where you want to
install the bike rack. The lowest hole of bracket
should be 50” from the ground. Mark holes for
drilling.
Drill Holes into wall, put the wall bracket back
up and insert wall anchors through holes in
bracket and set the anchors. For setting the
anchors and diameter and depth of holes,
follow instructions sent with the anchors. Make
sure bracket is level.
On cross beams, Place a mark three inches
from each end. This mark will show you how far
to slide the cross beam into the wall bracket.
1
3
4
2
TOOLS NEEDED
9/16” Wrench/Socket
3/8” or 1/2” Masonry Drill Bit
(Depending on anchor type)
Tape Measure
Drill (Hammer drill recommended)
Hammer
Level
Marker or pencil
Pin-in-hex tool (provided)
NOTE
Before installing make sure the wall is strong enough to
accommodate the rack fully loaded with bikes. Steel stud walls are
not suitable for installation
3”
3”
Mark holes
50” to ground
