For Customer Service Call
800.333.8519 (U.S.A.) or
541.955.9199 (International)
Manufactured by Krauss Craft, Inc.
www.playcraftsystems.com
SPIRAL STEP CLIMBER
INSTALLATION INSTRUCTIONS
Rev H
7/2/2013
R3.5-1234
Page 3 of 4
Step 2
(Factory Assembled)
Attach Spiral Step Climber Treads to the
Spiral Step Climber as shown in Figure 1.1.
(See Note A)
Step 3
Place Spiral Step Climber into footing hole and
attach to deck as shown in Figure 1.2.
(See Note A)
Step 4
Fully tighten all fasteners according to the
"TIGHTENING TORQUE FOR HARDWARE"
section of the Installation Manual.
Step 5
Plumb and level entire component. Pour concrete
into footing hole. Allow at least 72 hours to cure
before using this equipment. (See Note B)
Step 6
Place required protective surfacing under and
around Spiral Step Climber. (See Note C)
Figure 1.1
SPIRAL STEP CLIMBER
3/8" Black Cap Nut
3/8" x 7/8" O.D.
Washer
3/8" x 7/8" O.D.
Washer
3/8" x 1-1/4"
Button Head Bolt
SPIRAL STEP
CLIMBER TREAD
Figure 1.2
3/8" x 1-1/4"
Button Head Bolt
3/8" x 1" O.D.
Washer
3/8" x 1" O.D.
Washer
3/8" Lock Nut
SPIRAL STEP
CLIMBER
