Manufactured by Krauss Craft, Inc.
www.playcraftsystems.com
For Customer Service Call
800.333.8519 (U.S.A.) or
541.955.9199 (International)
STACKED LOOP CLIMBER
Rev D
12/16/2009
1224
Page 3 of 3
Maintenance Manual.
Periodically tighten all screws, bolts and nuts. A
periodic inspection of all parts is necessary. If a part
is broken or worn, replace immediately. For general
maintenance please refer to our Playground
Maintenance
Specifications
Parts List
Part #
DESCRIPTION
QTY
Varies
Stacked Loop Climber
1
9103032-TR
Bolt Button Head 3/8" x 3/4"
4
9333002
Washer Flat 3/8" x 1" O.D. x .100" thick
4
9345002
Washer Flat SAE 1/2"
4
9443022-TR
Nut Barrel 3/8" x 5/8" BH
4
Plumb and level entire component. Pour concrete
into footing holes. Allow at least 72 hours to cure
before using this equipment. (See Note B)
Step 5
Place appropriate compliant protective surfacing
under and around Stacked Loop Climber.
(See Note D)
Step 2
Attach Transition Wall to deck. Place Stacked
Loop Climber into footing holes and attach to the
Transition Wall as shown in Figure 1.1.
(See Notes A & C)
Step 3
Fully tighten all fasteners according to the
"TIGHTENING TORQUE FOR HARDWARE"
section of the Installation Manual.
Step 4
STACKED LOOP CLIMBER:
Shall be constructed of 1.660" O.D 11 gauge steel
tubing and connecting rails with welded 1.315" O.D.
12 gauge steel tubing loops . The Stacked Loop
Climber has a multi-stage baked on powder coat
finish.
HARDWARE:
Shall be stainless steel, zinc/nickel plated or
galvanized as required to resist rust and corrosion.
3/8" x 3/4"
Barrel Nut
1/2" SAE Washer
3/8" x 1" O.D. Washer
3/8" x 5/8"
Button Head Bolt
TRANSITION WALL
STACKED LOOP
CLIMBER
Figure 1.1
