background image

TRAINING

COMPETITION

TIPS & TROUBLESHOOTING

GAME ON

Need to familiarize yourself with the laser field before going on your first secret 

mission? Go ahead with a training mission!
• Switch the back of the Bomb to SINGLE.

• Press the START button on the front of the Bomb.

• Position yourself at the beginning of your laser field.

• Begin weaving through the field, avoiding touching the string. Do this like a real 

spy, stepping over some strings and crawling or dipping under others. Make it 

fun!

• If you touch the string, the Bomb will buzz to let you know. In this training 

mode, there is no time tracking.

• Pick up the Gear Cards as you go. If you miss any, then your mission will not be 

successful!

• When you make it to the Bomb, press the FINISH button to defuse it!

• 

More fun with SINGLE mode: Set up the string in your room to detect intruders! 

When someone enters, touching the string, the Bomb will make a sound to alert 

you of their presence!

Ready to go on a secret mission, with time counting down? Maybe challenge your 

friends and see who’s the quickest spy? Let’s do it!

• Switch the back of the bomb down to CHRONO.

• Select the Bomb countdown, from one minute to 10 minutes, by pressing the TIME 

button on the front of the Bomb.

Remember: In CHRONO mode, each time the string is touched, 20 

seconds is deducted from the time! If you touch it hard enough, you 

could lose up to 60 seconds!

• Maneuver through your laser field, avoiding touching the string. Do this like a real 

spy, stepping over some strings and crawling or dipping under others. Make it fun!

• Pick up all of the Gear Cards as you go. Your mission will not be successful if you 

don’t get all of the Cards.

• Audio cues: When the Bomb gets to only 60 seconds left on the clock, the

beeping will speed up. When it only has 30 seconds left, the beeping will speed

up even more.

• When you make it to the Bomb, press the FINISH button to defuse it! If you

made it in time, and you picked up all the Cards, you completed your mission 

successfully!

• If the Bomb goes off before you get to it, or you failed to collect all of the Cards, 

your mission was unsuccessful. Try again!

Spies can be competitive, so if you want to challenge your friends (or yourself),

go for it!
• Take turns going through the laser field and keep track of the Bomb time when it 

gets defused (the screen will display the time). 

• You want to try to be the spy who gets through the laser field the fastest. This 

means you want the most time left on the Bomb countdown when you defuse it.

• Who had the best time? You are the best secret spy!

• Who sets up the laser field if multiple players are going to compete? Everyone 

helps! Or take turns making different laser fields!

• Challenge yourself to get quicker going through your laser field. A spy can never be 

too good, right?

• If your string is falling off of the Clamps, try adjusting the tension. It may be

too tight or too loose.

• If the Sensor falls off of its Clamp, adjust the Clamp location or adjust the

string tension.

• If the Bomb keeps making noise or counting down in chunks of time as if the string 

is being touched, but it isn’t, check that the Sensor is level. If it is not level, this will 

affect its sensitivity.

• When setting up your laser field, be sure to place clamps higher and lower so you 

get a good variety of heights to maneuver through.

• Attach the Clamps to sturdy, stationary items that will not move easily.

• It is best to clamp the Standard Clamps to a horizontal surface, such as the edge

of a table or desktop. Clamping to a vertical edge like a table leg may cause

poor performance.

• When passing the string through the connection point of the Clamps, try to position 

it close to the top, not touching the flat base as it curves around the connector.

• Try to avoid attaching Clamps at fully opened position. If the item you are clamping 

onto is too big, and the Clamp cannot “give” and “grab,” it may pull off easily.

Start Button

Finish Button

Time Button

Finish Button

Summary of Contents for Chronobomb Nightvision

Page 1: ...ggles to see the strings and bomb at night First you ll need to power the Bomb and that requires three AAA batteries Same goes for your trusty night vision Goggles See last page for details Once your Bomb is powered it s time to set up your string laser field Connect the Bomb s wire to the Sensor diagram A Fit the Sensor on the Sensor Clamp diagram B Clip the Bomb and Sensor to part of your game e...

Page 2: ...iagram F Once everything is installed adjust the string tension by winding the Reel Clamp diagram F Place the Gear Cards all along the string laser field to increase the game s difficulty The player must pick them all up before diffusing the Bomb Sample setup Sample setup Check that the Sensor and Bomb are properly connected Make sure your laser field is installed well Push the switch in the back ...

Page 3: ... button to defuse it If you made it in time and you picked up all the Cards you completed your mission successfully If the Bomb goes off before you get to it or you failed to collect all of the Cards your mission was unsuccessful Try again Spies can be competitive so if you want to challenge your friends or yourself go for it Take turns going through the laser field and keep track of the Bomb time...

Page 4: ...ôtauPin EntrepôtA4 33610Cestas France Partsandcolors mayvaryfromthoseshown BATTERY INSTALLATION Bomb Battery Installment Goggles Battery Installment Alkaline batteries are recommended for best performance Remove the battery cover using a screwdriver and insert three AAA batteries as shown Then screw the battery cover back on Note The Bomb and Goggles will not function if the batteries are inserted...

Reviews: