12
©
2006 Pacific Cycle, Inc.
4
Locate the slide front legs and insert them into the
front hand rail tubes, on the underside of the slide.
Align the holes and secure with the screws,
washers and lock nuts.
Part Ref. #: PSHW24
5
Slide the two ladder steps onto the legs of the slide.
Align the holes and secure the steps with the
screws and locking nuts. The screw head should
be facing the outside.
NOTE:
Once assembled and the slide is standing
upright, the steps should be flat and parallel with
the ground. If they are at an angle, they will need
to be removed, turned around, and reassembled.
Part Ref. #: PSHW5
6
To attach the slide to the frame, locate the two link
bars, remove the hardware, and re-attach to the side
support bar with the corresponding holes. When
reassembling the hardware, make sure that the lock
washers on the slide railing are located on the same
side as the link bar.
Part Ref. # PSHW17
TIP:
In order to keep the slide legs from sinking into the ground, place a flat rock or a brick under the legs. You should dig
out a place for the brick so the slide remains even.
IMPORTANT LAST STEPS!
TIGHTEN ALL HARDWARE. Do not allow children to play on the swing set until it is fully assembled, all items are
tightened, and the unit is properly anchored.
•
Do not over tighten nuts and bolts. Once they are tight, turn them ½ rotation more to be sure they are secure.
•
Check all parts on all rides before allowing a child on the swing set.
•
Be sure to check and tighten the hardware on a regular basis to ensure the safety of the users.
Your Playsafe™ Bristol Swing Set should now be fully assembled!
