6
©
2006 Pacific Cycle, Inc.
PRE-ASSEMBLED HARDWARE
For easier assembly, Playsafe™ has pre-assembled some of the parts for you. Most of the screws and bolts should already be
in place. If removal of this hardware is required for certain assembly steps, it should be replaced in its original position.
Hardware shown in the assembly steps are actual size.
MAIN FRAME ASSEMBLY
Required Parts:
Top
Bar
x2
Leg
x4
Support Bar x2
Corner Leg Fitting x2
Pre-Assembled Parts:
•
Corner Leg fittings should be attached to the top bar section.
•
Swing hooks should be in place on the top bar.
•
Hardware for the legs should be in place in the corner leg fittings.
•
Hardware for the support bars should be in place on the legs.
Step Illustration
Instructions Hardware
Reference
1
Attach the top bar sections. Remove the
pre-inserted hardware and join the two
sections together. After connected, align
the holes and re-insert the hardware to
secure.
Part Ref. #: PSHW10
2
Remove the hardware from the arm of a leg
fitting in order to insert one of the legs.
Then, align the two sets of holes and
replace the hardware through the leg fitting
arm and leg to secure.
Part Ref. #: PSHW10
3
Repeat the process for the other 3 legs.
Once completed, stand the frame upright.
Part Ref. #: PSHW10
