9
Items for
STEP 2:
Left-hand
Right-hand
Attach sturdy-frame brackets onto separate swing post
assemblies (brackets are stamped R and L).
Lay bracket on the flush end of post as shown. Slide bracket
over and down until it stops against the top and side of the
post as shown. When correctly positioned, the edge of the
sturdy-frame bracket will be parallel with the side of the post.
Use the bracket as a drill guide and drill two
¹₈
" holes 1" deep
into the posts. Attach with two #8 x 1
¹₄
" deck screws.
Again use the bracket as a drill guide and drill two
³₈
" holes
through the post. Secure bracket with two
³₈
" x 4" hex bolts,
³₈
" washers and
³₈
" lock nuts.
Repeat for each post.
Caution: Make sure bolts are tight
and the threads of each
bolt are at least flush to
the end of the nut to
ensure proper
engagement.
Note: Quantities will vary depending on the
materials used to build the A-Frames.
Stop
Stop
Stop
Stop
Rear View of bracket and
post assembly showing
correct position.
Rear View of bracket and
post assembly showing
correct position.
Free-Standing Swing Station
(4)
Swing Post Assemblies
(4)
Sturdy-Frame Brackets
(8)
³₈
" x 4" hex bolts
(16)
³₈
" washers
(8)
³₈
" lock nuts
(8)
#8 x 1
¹⁄₄
" deck screws
Extend-A-Bay Swing Station
3 Post
5 Post
(3) or (5)
Swing Post Assemblies
(3) or (5)
Sturdy-Frame Brackets
(6) or (10)
³₈
" x 4" hex bolts
(12) or (20)
³₈
" washers
(6) or (10)
³₈
" lock nuts
(6) or (10)
#8 x 1
¹⁄₄
" deck screws