13
Fig. 1
Fig. 2
RESIN DOCK TOP
WOOD OR COMPOSITE DECKING
Items for
STEP 4
:
(1) Ladder Assembly
When attaching the ladder to a dock with a Resin
Dock Top (PS 1320), align the holes of the top bracket
over the grooves of the Resin Dock Top and mark the
two outermost holes of the bracket as shown.
The side bracket needs to be marked at the first and
third hole up from the bottom as shown.
Repeat for the other side.
Remove the ladder from the dock and remove all four
brackets temporarily installed on the ladder.
When attaching the ladder to a dock with wood or
composite decking, align the holes of the top bracket
with the center of the planks and mark the two outer-
most holes of the bracket as shown.
The side bracket needs to be marked at the first and
third hole up from the bottom as shown.
Repeat for the other side.
Remove the ladder from the dock and remove all four
brackets temporarily installed on the ladder.
Set the ladder temporarily at the desired location as shown.
Make sure ladder is resting firmly against the top and side of
the dock. (Fig. 1 or Fig. 2)
Note
:
Failure to use the holes identified will create an interference when bolting brackets to the dock.
Warning: Do not install brackets over the joints of two
2' x 2' dock top sections. Brackets must be
installed on a continuous section of the Resin
Dock Top.
