26
TOILET
Please refer to the manufacturer’s operating instructions for
further information.
TOILET TROUBLE SHOOTING:
Water keeps running in the bowl:
check to see if the foot lever is all the way up. Sticking may
be caused by foreign material on the waste valve blade seal at
the bottom of the toilet bowl. If the problem persists, you may
need to replace the water valve.
The toilet leaks and there is water on the floor:
if the leak is at the back of the toilet, check the water supply
line connection and refer to the manufacturer’s installation
instructions. If the leak is at the toilet flange area (where the
toilet mounts to the floor), check the toilet flange nuts and
tighten them if necessary.
Poor flush pressure:
the lever must be held fully down during the flush. An adequate
flush should be obtained within 2 to 3 seconds. If the problem
persists, remove the water supply line and check the water
supply. The water supply rate should be at least 10 litres/2.5
US gal per minute to ensure an adequate flush.
KITCHEN FAUCET
(Dehco 82H09-CHRG)
With the faucet handle in the off position, the faucet may
continue to drip for a short period of time or when the vehicle is
moving. Water is retained in the faucet spout.
