Installation and user handbook – rev.0.4 of 23.02.2017
47
The components surrounded by a broken line, identified by this icon, make up
a basic set that is always present in all possible system configurations. For simplicity, these
components are not shown in other hydraulic drawings, but their presence is indicated by
the relative icon.
The connection drawing that is represented, just like those on the following pages, is purely
indicative and only indicates how to connect the hydraulic connections and install the main
supplied components and the requested accessories.
Hydraulic connection is the responsibility of the installer; he/she has the task
of verifying if what is indicated in this manual complies with laws and regulations in force at
the installation place.
The manufacturer is not liable for any damage caused to things and injury to people as a
result of installation carried out in a manner that is not state-of-the-art, and without
respecting local regulations and laws.
Indications on gaskets and connections
The external components of the
“EGO”
solar collector with integrated storage are all made
of plastic, to reduce thermal dispersion.
The connections were created for the use of gaskets with flat seal.
Only use the flat washers supplied with the collector and the valves to seal the
connections.
Do not use other types of seal or additional seals, such as hemp, Teflon, sealing paste or
similar. No guarantee rights will be recognised if seals or additions other than those
supplied are used.
When tightening the connections:
make sure the gaskets are positioned correctly;
use a spanner and a torque wrench;
use the spanner to keep one of the two connections steady, so that it does not move
from its seat, and to prevent damaging the connection;
tighten the other connection using the torque wrench, without exceeding a tightening
torque of 20 Nm.
Using flexible hoses
Only removable connections (e.g. stainless steel bellows and flexible pipes) must be used
to connect the water lines to the valves on the solar collector connections.
Summary of Contents for EGO 110
