26 / 53
5. Attach the feet plastic parts while paying attention to ensure the
wider side of the feet are towards the outside of the robot. Insert
the + side of the foot into the servo horn and then insert the
opposite side of the foot into the bump on the front side of the
thigh. *This may take some strength.
6. After fixing the feet to the servo motors, unplug the servo motors
from the control board and turn the power switch off.
Summary of Contents for PLEN:bit
