44 / 53
5. Bend the LED legs 90 degrees such that the head-board is rotated up,
and insert both LEDs into the semi-circular grooves in the bottom
plastic heat part such that the nuts on each LED are on the inside
of the head.
6. Align and place the top plastic head part onto the bottom part by
first passing the LED bulbs through the top heat eye holes.
Summary of Contents for PLEN:bit
