PX-63CS Internal Termination
The PX-63CS is shipped from the factory with its termination enabled (ON). To disable
termination, remove the jumper from the termination pins on the back panel of your
drive. Refer to the pictures on pages 10 and 14 for the location of the termination pins
(labeled ‘‘Term’’). They are the fifth set of pins from the left.
If your drive already is installed in your computer, be sure to turn off your computer
power before removing (or reinstalling) the jumpers. We recommend that you retain
the jumpers so you can reinsert them onto the termination pins if you later need to
turn the drive’s termination ON.
PX-65CS External Termination
The PX-65CS is shipped from the factory with its termination turned ON.
To turn the termination OFF, first turn off the drive’s power, then change the second
DIP switch on the rear panel of the drive to the OFF position. Refer to the pictures on
pages 12 and 16 for the location of the termination switch (labeled ‘‘Term’’). It is the
second of the five switches.
CHAPTER 7 ---- Termination
PX-63CS/PX-65CS OPERATION MANUAL
19
