ÜG-Vfg.243
FCC NOTICE
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant
to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses, and can radiate radio frequency
energy, and, if not installed and used in accordance with the instructions, may cause harmful interference
to radio communications. However, there is no guarantee interference will not occur in a particular
installation. If this equipment causes harmful interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is encouraged to try to correct the interference
by one or more of the following measures:
•
Reorient or relocate the receiving antenna.
•
Increase the separation between the equipment and receiver.
•
Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.
•
Consult the dealer or an experienced radio/TV technician for help.
Any changes or modifications should be approved by the party responsible for compliance of FCC Rules;
otherwise, the user loses authority to operate the equipment.
CAUTION: Use of controls or adjustments or performance of procedures other than those
specified herein may result in hazardous radiation exposure.
The laser beam emitted from the optical pickup is invisible. Accordingly:
•
Do not open the optical pickup housing.
•
Obtain service only from Plextor-authorized personnel.
LASER INFORMATION
These products have been designed and manufactured according to IEC 825-1 on the Safety of Laser
products. This product comes under “Class 1 Laser Products.” A Laser Caution Marking is attached on the
top of the internal drive model: “Caution: Invisible laser radiation when open. Avoid direct exposure to
beam.”
CAUTION: To disconnect the CD drive from an electrical current, pull out the power plug.
VORSICHT: DIE TRENNUNG VOM NETZ ERFOLGT DURCH ZIEHEN DES NETZSTECKERS.
Zur Einhaltung der Funk-Entstörung von nicht selbständig betreibbaren
Hochfrequenzgeräten (periphere Anlagenkomponenten).
Dieses Gerät entspricht als Einzelgerät den Funk-Entstöranforderungen der
Postverfügung Nr. 243/1991.
Wird das Gerät innerhalb einer Anlage zusammen mit anderen Geräten
betrieben, so muss bei Inanspruchnahme der “Allgemeinen (Betriebs-)
genehmigung” nach der BMPT-AmtsblVfg Nr. 243/1991 die gesamte
Anlage folgenden Richtlinien entsprechen:
•
Grenzwertklasse B der EN55022
•
Auflagen nach § 2 der BMPT-AmtsblVfg 243/1991
Dies ist bei der Zusammensetzung einer Anlage (z.B. Computersystem) aus nur einzeln geprüften Geräten
nicht immer erfüllt.
