Section 2. Installing Your PlexWriter SCSI Drive
16
PlexWriter 12/10/32S Operation Manual
Factory SCSI Jumper Settings
Figure 6 shows the factory settings of the SCSI jumpers. The functions shown are
ON if the jumpers are installed and OFF if the jumpers are removed.
Figure 6: Factory Settings for Jumpers at the Rear of the Internal SCSI Drive
Changing SCSI Jumper Settings
To remove a jumper, pull it off with your fingers or a pair of needle-nose pliers.
CAUTION: Ensure power to the drive is OFF before installing or removing jumpers.
To add a jumper, push it onto the jumper pins. In addition to the three jumpers
already installed at the factory, extra jumpers are supplied with the PlexWriter drive.
Figure 7: Install Jumpers Across Vertical Pairs of Pins
CAUTION: Install jumpers across each pin as shown (vertically). Do not connect one
pin switch to another by installing the jumpers lengthwise (horizontally). Doing so
could result in damage to the drive.
