Add More CrewCom Devices
If you need to add additional CrewCom devices (e.g., a Hub, RT, or additional Control Units) after you’ve applied your
CrewCom Configuration File, you'll need to do the following:
1. Add the device(s) to your system diagram in CrewWare, then save the Configuration File change and apply the
new Configuration File to your system. (Remember, you cannot make System Diagram changes while
CrewWare is "live.") (See the
for information on building a system diagram and uploading
the configuration file (CCF).)
2. Connect the additional CrewCom device(s) via an available CrewNet RJ-45 Copper or duplex LC Fiber port.
Operation - 31
Summary of Contents for CrewCom CHB-8C
Page 1: ...Hub OPERATING MANUAL...
Page 2: ...ii...
