12
SETTING THE PROCESSOR SWITCH
The processor switch needs to be in ‘bypass’ when listening to music directly from selected source inputs
such as CD or tuner. If you are not using an external processor in either way as described above, ensure
this switch is set to ‘bypass’. The Plinius 8200 does not amplify any input other than processor ‘return’
when this switch is set to ‘processor in’ mode.
RECORDING MUSIC
In order to record music to tape, or some other line level recording device, these devices will need to be
connected to the tape 1 and tape 2 outputs. Turn the record selector on the front panel to the input you
wish to record from, and the amplifier will now send signal to both tape 1 and tape 2 outputs. Note that
the volume control does not adjust the recording level: this is done at the recording device itself.
USING PRE OUT
A line level output is provided on the back of the Plinius 8200. If you wish to use the Plinius 8200 as a
pre-amp only, or to send signal to another amplifier, fit the interconnect cable to the pre out outputs. Note
that the pre out connections provide signal from whatever the source selector knob is currently set to.
TERMINATION QUALITY
Quality of the connections must be examined to ensure that high-performance, trouble-free operation is
enjoyed. Check that the connections are tight but do not over tighten. If bare wires are used make sure
that no loose strands of wire short across the other terminals or the amplifier chassis. When using plugs
such as bananas, be sure to use good quality plugs with a firm fit.
BI-WIRING
Bi-wiring uses two pairs of loudspeaker cables for each channel loudspeaker. You will notice that the rear
panel of your Plinius 8200 has two pairs of output terminals for this purpose. When using bi-wires,
always connect positive (+) to positive (+) and the same for the negative (-) terminals.
PHASING (OR POLARITY)
It is important to achieve good stereo imaging in your listening room. By observing the wiring
instructions above, each power amplifier/loudspeaker combination should be in phase. If you experience
poor stereo image and/or a lack of bass, check that the loudspeaker wiring has been connected correctly.
We recommend that you use one of the easily obtainable ‘test discs’ to help you ensure both phasing and
channel orientation are correct. If in doubt, consult your PLINIUS
PLINIUS
PLINIUS
PLINIUS dealer for advice.
Summary of Contents for 8200 MkII
Page 1: ...C l a s s A B I n t e g r a t e d A m p l i f i e r...
Page 2: ...2...
