13
For XLR input connection, make sure you connect the RIGHT XLR input and LEFT XLR
inputs to the right and left outputs from your Preamplifier respectively.
Use the Amplifier Configuration Selector switch to select RCA STEREO if you are using
unbalanced RCA inputs or to select XLR STEREO if you are using balanced XLR inputs.
Preamplifier Output
Interconnects
SA-Reference Input
NOTE:
DO NOT connect XLR and RCA at the same time, use only one or the other.
Detailed instructions for using the SA-Reference in RCA BRIDGED MONO, and XLR
BALANCED MONO modes are later in this section.
LOUDSPEAKER OUTPUTS
The connection of your loudspeakers to the output posts of the PLINIUS SA-Reference
must be made by an ‘instructed person’ or by ready made loudspeaker cables only.
Connect your left loudspeaker (ie. the one on your left when seated in your normal
listening position) to the left output terminals, ensuring that the red positive (+) terminal
on the amplifier is connected to the red positive (+) terminal on your loudspeaker. Do the
same with the black or negative (-) terminals. Repeat this process for the right outputs.
SA-Reference Output
Speaker Cables
Speaker
