Replacement
Adjustment
20 September 2006, Rev 0.01
3-57
SENSORS AND SWITCHES
3.5.19 SW5 FOLD KNIFE MOTOR (M10) HOME POS. SWITCH
Removal
1. Switch off the main power switch.
2. Remove the Left cover (Front cover (
3.3.1 ) or Rear cover (
3.3.2 )
depending on model).
3. Disconnect the connectors [A] (
x1 ).
4. Remove the screws [B] and remove the switch [C] ( x2 ).
Installation
1. Reverse the removal procedure
Adjustment
1. Switch actuator should be placed in the middle position of the switch.
2. With the knife in position (against mechanical stop), there should be 0,5-
1,5mm play between switch arm and knife beam when switch arm is bottomed
out.
NOTE:
The knife cam is follower is normally outside cam in home position
which allows performing the adjustment.
[B]
[C]
[A]
