2
43
If you want to turn the Creaser off select Off and press
[Ok] to confirm.
If Creaser was Off, the first choice will be Off and vice
versa. Select On or Off with the [arrow] button and
press the [OK] button.
From the Ready screen, select Bleedt Trim and press
the [Change] button.
The Bleed Trimmer trims the long sides of the sheets
to shape the print-outs into the desired format. You
can adjust three different parameters and in all three
parameters you have to make sure that the inboard
(IB) and outboard (OB) shreds are within the interval
of 5-30 mm to avoid *Bleedtrim Conflict*.
Bleed Trimmer - Selecting On or Off
Creaser - Selecting On or Off
Bleed Trimmer - Selecting Bleed Trim Mode
The Width In Parameter collects its value from the
Booklet Maker. If you want to change the value, select
Width in and press the [Change] button. Width in stands
for the width the sheet has before it enters the RCT 30
unit (or the Booklet Maker).
Summary of Contents for BOOKLET MAKER Pro 30
