plottiX iXpress, User Manual

Operating Instructions 

Operating Instructions 

7

1

Before using the Transfer Press put the power 

plug into the power outlet. Make sure that the 

mains voltage of the outlet matches the idica-

ted mains voltage of iXpress Transfer Press. 

Place the iXpress Transfer Press on the heat-re-

sistant base and start the device by pushing 

the Power button.

Note:

Unplug the device from the power outlet when 

not in use.

2

Set your desired temperature (TEMP Button) 

and time (TIMER Button) as explained on page 

5. 

(See recommended settings for plottiX heat 

transfer foil on page 8 or visit our Website: 

www.plottix.de for further informations.)

4

Place your textile on the silicon matt while Trans-

fer Press is preheating.

Pre-iron the fabric with iXpress Transfer Press for 

3-5 seconds to remove creases and moisture.

Place the design on the fabric.

Warning:

Note that the hot surface only contains 

the desired medium for pressing and the 

design. Risk of bruises.

5

Cover the design with the heat-resistant 

sheet that came with the Press.

After that place the Transfer Press on the heat 

resistant sheet. Push the TIMING button to 

start the countdown.

6

Use pressure until the countdown ends. Alarm 

signal will occur when countdown is over. Push 

TIMING button to stop the countdown and 

deactivate alarm signal. 

Turn over your project and press the backside 

of your design. Note the recommended press 

time of your foil.

Warning:

Please note that the Transfer Press heats up 

accordingly to set temperature. Risk of burns 

by touching.

8

Your transfer is complete! 

Place your iXpress Transfer Press back on the 

heat resistant base and pull out the power plug. 

Wait until the iXpress Transfer Press has cooled 

down completely. After that you can store it.

3

After setting temperature and time the Transfer 

Press starts preheating. 

Please wait until the temperature display has 

reached the set temperature. While preheating 

the press must be placed on the heat resistant 

base. 

Warning:

Please note that the Transfer Press heats up 

accordingly to set temperature. Risk of burns 

by touching.

7

See if the transfer foil  lifts up easily. 

If it doesn’t, reapply the Transfer Press for a 

few more seconds.

Peel off the transfer foil according to your 

transfer foil specifications (warm or cold 

peel).

6