7
Installation
Installation
Fitting sequence
Please refer to the following pages for accompanying installation diagrams.
When positioning the lift into the vehicle:
1. Roll off ramp (wheels) must be clear of rear doors, minimum 15mm.
2.
When the lift is powered “down” t
he bridge plate mechanism must be clear
of the rear bumper or side valence.
3. The distance between the inside of the door aperture and the outside
of the handrails should be equal both sides.
4. All manual override systems must be fully accessible.
5. The vehicle surface MUST be flat. Do not attempt to mount base plate on top of seat
tracking extruded sections. Shim base plate above tracking if necessary.
If the surface is not flat, when the lift is bolted down the base could distort to the
contours of the floor. This will have the effect of altering the position of the lifting arms,
thus twisting the lift.
THIS WILL AFFECT PRODUCT WARRANTY.
When bolting in the base:
1. PLS universal fitting plates should be used instead of washers!
2. At least two of the front bolts (closest to driver) should be located through the
vehicles chassis.
NB. WHEN FITTING EAB A “FULL” REAR BEAM MOUNTING BRACKET SHOULD
BE USED.
Adjusting lift:
1. Ensure vertical stow position is set correctly.
2. Ensure horizontal platform position is set correctly.
3. Ensure roll-off ramp end of platform lands on ground first.
4. Ensure platform is symmetrical (not twisted)
5. Ensure Platform gates are locating together correctly.
6. To correctly adjust the Platform Knuckles
see Platf
orm Gates “Synchronizing”
Procedure in section 7.4
To Finish:- Weight Test Lift to current LOLER recommendation/ regulations.
1. Check all fitting bolts are tightened to correct torque setting.
2. Check all lift fastenings are tight.
3. Ensure all information decals are positioned correctly.
4. Lift serial number and SWL are visible.
5. Fill in weight certificate.
6. Fill in LOLER certificate.
7:2 General Installation Access™ EA & Access™ EAB
1.01
4.01
.0
3.02
2.15
2.19
2.21
3.04
7
7.2 General Installation Access™ EA & Access™ EAB
