6
OI remote control for Pluggit Avent
3.3.
SETTING THE TIME
1. Press the centre of button (1) to activate the operating
mode line. The current operating mode flashes
2. Press button (1) at the right until the hands of the
clock (2) start flashing.
3. Press the bottom of button (1) and the current time
starts flashing on the display (3).
4. Hold down top or bottom of button (1) until the time is
set.
5. Press centre of button (1).
The setting is saved and the weekday (4) starts flashing.
6. Press top or bottom of button (1) until the weekday (4) is
set.
7. Press centre of button (1).
The setting is saved.
3.4.
SWITCHING ON/OFF PRESET WEEKLY
PROGRAMME OR AUTOMATIC PROGRAMME
You can choose between a total of 10 preset weekly pro-
grammes or one automatic programme (freely selectable).
In automatic mode the room ventilation unit automatically
switches between the different ventilator levels. The room
ventilation unit maintains the air quality with regard to the
relative air humidity and the VOC content at the same the
same level of comfort.
In high humidity the demand increases and the room venti-
lation unit switches to ventilator level 3.
In low humidity the room ventilation unit turns to
ventilator level 1.
If a humidity sensor (accessory) and a VOC sensor (acces-
sory) are installed, the room ventilation unit turns to
ventilator level at high VOC levels.
In the preset weekly programme the ventilator levels
change depending on the stored times, see page 7.
Automatic programme
1. Press the centre of button (1) to activate the operating
mode line. The current operating mode flashes.
2. Repeatedly press button (1) at the right until the
display (2) illuminates.
The ventilator level (3) which has just been set will be
displayed.
3. Press centre of button (1).
The setting is saved.
Preset weekly programme
1. Press the centre of button (1) to activate the operating
mode line. The current operating mode flashes.
2. Repeatedly press button (1) at the right until the
display (2) starts flashing.
The current weekly programme (3) is displayed.
3. Press the bottom of button (1).
The weekly programme (3) starts flashing.
4. Press top or bottom of button (1) until the desired
weekly programme (3) is selected.
5. Press centre of button (1).
The settings are saved.
Note:
One preset weekly programme or the automatic pro-
gramme must be selected when commissioning the
unit. For further information, please refer to the oper-
ating and installation instructions of the room ventila-
tion unit.
Die Wohnraumlüftung
RH%
2
4
3
1
M+P-26A-0968
Die Wohnraumlüftung
RH%
2
3
1
M+P-26A-0969
Die Wohnraumlüftung
RH%
2
3
1
M+P-26A-0970
