Attention:
When not all placed plugs appear in the list, this can be due to one of the following reasons:
Not all plugs have been signed on or recognized by the network:
-
If multiple networks are active in the immediate surroundings, the process to sign on the plugs may take a
little longer. After approximately 5 minutes all plugs should appear on screen.
One or more plugs are unreachable:
-
When a plug is placed too far from the others it cannot communicate with the network. To solve this you can
place the plug closer to the others or place another plug in between the unreachable plug and the others.
Please make sure that the distance between the plugs is no more than 5 meters.
The plug does not work:
-
If both abovementioned steps do not lead to a complete picture of your network in the screen of ‘Select
Modules’, you may reset the plug. For a complete explanation of this procedure we refer you to the Detailed
Manual to be accessed by clicking on the Question-mark Icon on the lower right side of the program.
•
The Wizard will guide you further through a number of screens to entering data in order to create a network.
Proceed with all the steps of the wizard and click on ‘complete’ . The system will be activated.
•
Save the installation list with the Licence Code.
Use software
Your Energy Management System is now installed! By using the software you can now measure and switch your appliances.
You can save on your energy-consumption by sending switching schedules to the plugs. As a service you may find hereunder
a software-window with instructions.
Technical information
The computer can be switched off whilst the system continues to operate. The plugs have their own memory so even when
the computer is not switched on the measured data are stored and the plugs will switch according to the switching schedules
you entered. As soon as the computer is switched on (with the Stick connected) the stored data are retrieved from the plugs
and the complete overview of the energy-consumption is realized.
In order for the software to communicate with the products the Stick should be kept connected to the computer. You may
disconnect the Stick however this leads to interrupted communication between the plugs and the computer which means
that the current usage is not displayed and new usage data are not claimed. The disconnection does not interrupt the
actions of the network or the data already stored in the software, like the switching schedules. As soon as the Stick in
connected to the computer again, the software program will have to be started again. The computer then retrieves all data
stored in the plugs and in case new switching schedules are entered, they will be activated.
Switching,
program switching
schedules in order to save.
Overviews,
look at reports and
graphs of the energy consumption,
the costs and the CO2-emission.
Direct Switching,
the
cted appliance or group
rectly switched on/off
.
Usage data,
preset the timeframe
for use. The graph is empty until
data have been received.
Settings,
add plugs, create groups
and rooms.
tick,
the Stick flashes
hen data are retrieved
