Pressure recorder MacR6-P
Installation manual v1.0
– December 2017
3
3. SENSORS CONNECTION
Connect the pressure sensor to the gas flow installation. (MacR6-Z0-P & MacR6-Z0-P/2P):
It is required to connect the sensor using the shut-off valve.
Pressure sensor in MacR6-Z0-P device
Before assembly pressure sensor it is required to reset its indications (compensation of atmospheric
pressure). It can be done via Android application (by option in menu Options/Pressure Zero/Make fixes
and Save data) or via PlumCONF application (set „P offset st.”
parameter to value: 1 =>for 1-pressure
sensor version of device
). “P CAL” will be shown on LCD.
After pressure sensor assembly it is recommended to perform SEr 8 menu to begin pressure
measurement test (measurement every 5 seconds for one minute). Value of pressure will be shown on
LCD.
4. CONNECTION WITH SMARTPHONE
•
OptoBTEx Bluetooth pairing code: 1234.
Blue QR code
contains the movie presenting proper
connection between smartphone and MacR6 device.
LED diode must be on the right side looking on the front of the MacR6. During
transmission its musts flash constantly.
Configuration using computer is more detailed in „Configuration using PC”
section.
5. COMMUNICATION WITH THE DEVICE
•
Through correct device readout on the main screen will be presented the device nameplate. It
consists of devices name, variant, serial number, firmware version. After loading all the parame-
ters, the application will proceed to main configuration window.