Automist Smartscan
®
Handbook v1.2.3
Plumis Ltd Copyright © 2017. All Rights Reserved.
Page 15 of 64
S MA RT SC AN
®
the nominal spray pattern in that direction should be reduced from a 90 degree quarter circle, to a 45
degree arc pointing away from the wall:
, below, shows the result when both sides could be
obstructed.
Figure 4:
With spray head not in a Preferred Position, the visible area’s full
-angle must
be assumed to be only 90° due to potential obstructions either side of the spray head.
Note: this is not a complete layout
–
additional spray heads would be required to complete the scheme.
If the reduced spray pattern leads to a large shadow area, additional spray head(s) may need to be used in
order to complete the room coverage.
6 below show the logic behind this rule.
Figure 5: Installation in Preferred Position between window and wall. Use of preferred position ensures that
insertion of a bookcase after installation has low consequences - grey shaded area is approximately 0.3m2.
