8
OPERATION
Moving the writing surface
Use the auxiliary cable to connect the COM Port on the PC and the PC COM connector (9 pins) on
the board to the auxiliary serial cable.
Install the board ware software in the PC.
Use the board ware software to download the writing surface data to the PC.
The PC ONLINE lamp on the unit switch panel lights up when the boardware starts up and
the "Repeat" key changes to the "Download" key. The Repeat function is now inoperable.
Consult the board ware software manual for the connect installation and operation of the
software.
Moving with the keys.
Press the Feed/Stop key. When the key is
pressed, the writing surface moves to the left
the equivalent of one page and then stops.
If the Feed/Stop key is pressed during
movement, the unit immediately stops.
Moving manually
It is also possible to move the writing surface
manually. The sheet can be moved in this
case either to the left or right. Avoid moving
the writing surface too quickly manually as
this could cause malfunctioning.
Downloading data to the PC
Making Additional Copies (Repeat)
To make a single copy
Press the Repeat key.
The 1 additional sheet is printed out from data
that was just copied.
There is no need to set several sheets
when making only 1 copy.
To make additional copies
Set the number of copies needed with the
[+] or [-] keys.
Press the Repeat key.
The copies are printed out from data that was
just copied.
A maximum of 99 copies can be set.
The Stop key is disabled during printout.
Be sure to set the correct number of copies.
PLUS BOARDFAX
BF-030SPP
POWER
POWER ON
PC ON LINE
REPERT
STOP
FEED
ERROR
DONWLOAD
Download key
PC ONLINE LAMP
