E-36
IP Address=*
Subnet Mask=*
Default Gateway=*
Input the IP address (fixed).
Input the subnet mask.
Input the default gateway if necessary.
Contents upon purchase and when network settings are reset
Item
Item name
Setting
Default
IP address
IP Address
Any value
Blank
Subnet mask
Subnet Mask
Any value
Blank
Default gateway
Default Gateway
Any value
Blank
Save the “setting.ini” settings file, overwriting the
previous file.
Save to location: “setup” folder on copyboard (removable disk)
File name: setting.ini
• We recommend making a note of changed settings for future refer-
ence.
Once overwriting is completed, the copyboard reboots
automatically.
Perform the USB disconnection procedure on the computer (see
step 3 on page E-22), then disconnect the USB cable.
Check the connection.
1 Connect the copyboard to the LAN port on a switching hub, etc.
2 Launch a web browser (ex.: Internet Explorer) on a computer con-
nected to network.
3 In the address field, input “http://” followed by the IP address that
was set, then press the [Enter] key.
If the copyboard’s top screen opens, the copyboard has been cor-
rectly connected to network.
If the copyboard’s top screen does not open
This could be due to one of the following:
• Have you made a mistake inputting the IP address that was set?
• Is the copyboard’s LAN terminal properly connected to a LAN port
on the network?
• Is the IP address that was set being used by another device?
• If multiple units of this copyboard are connected, are they con-
nected to the network with the same IP address?
• Is the IP address that was set within the automatic acquisition
range of the DHCP of the router, etc.?
• When using a proxy server, add the copyboard’s IP address to the
“Exceptions” in the proxy’s settings to set so that the proxy is not
used.
CB Setup and Network Setting Procedure
Summary of Contents for N-204
Page 54: ...26 4606 11C...
