20
3. Click
on
OK
button to save settings and exit.
Warning
To completely shut down the scanner, press the
power switch on the side of the scanner.
If the scanner will not be used for a long period
of time, shut down the scanner and then
disconnect the power cable from the power
outlet.
Alternatively you may click
Default
to restore the default settings. You may press
any scanner button to wake up the scanner from power saving.
C
ALIBRATING THE
S
CANNER
Calibrate the scanner if colors appear in areas that should be white, or colors of the
scanned image and the original vary a lot. This allows you to adjust and compensate
for variations that can occur in the optical component over time by its nature.
1. From the Windows
START
menu, point to
All Programs
>
Your Scanner
Model Name
, and then click
Scanner Utility
. (For Windows 8.1 users: Point
your mouse cursor to the upper or lower right corner of your screen to open the
Charm
bar. Click on the
Start
charm, then click on the downwards arrow button
in the lower left corner of the screen. The
Apps
screen will be shown. Move
your cursor to the right edge of the screen to scroll right until you find
Your
scanner model name
, and then click on
Scanner Utility
.)
2. The Scanner Utility window opens. Find the
Calibration Settings
section and
select
Flatbed Reflective
as the scan source. Click the button of your option:
a. Set the scanner to perform calibration before a scan only if the scan setting
"Scan Mode" or "Resolution" is modified: Click the button before
Perform
calibration before scanning if the scan mode or resolution is changed
.
b. Set the scanner to perform calibration before a scan: Click the button
before
Always perform calibration before scanning
.
c. Set the scanner to automatically perform calibration: Click the button before
