13
5. Click on the check mark button when the alignment has been completed.
Lamp Control
The scanner’s lamp may be turned ON and OFF manually in the Scanner Utility
program. While there, you can also set a timer to turn the lamp off after the scanner
has been idle for a designated amount of time.
To do this, click on the Windows START button and choose PROGRAMS,
PLUSTEK EPP SCANNER, SCANNER UTILITY. In the window that opens, find
the Lamp Control section shown below:
Click on the On/Off switch at the far right of the section to immediately turn the
scanning lamp on or off.
You may also set the default time for the lamp to automatically turn off after a
scan by clicking the up or down arrows next to the area that reads “minutes to turn off
lamp.”
Maintenance
To keep your scanner working smoothly, take a moment to review the following
maintenance tips.
•
Avoid using the scanner in a dusty environment. When it is not in use, keep the
scanner covered. Dust particles and other foreign objects may damage the unit.
•
Do not attempt to disassemble the scanner. There is danger of an electrical shock
and opening your scanner will void your warranty.
•
Do not subject the scanner to excessive vibration. It may damage the internal
components.
•
Be sure not to bump or knock the scanner glass as it is fragile and could break.
•
Clean the scanner glass by lightly spraying a non-abrasive glass cleaner onto a lint-
free cloth. Then, wipe the glass thoroughly with the cloth. DO NOT SPRAY
CLEANER DIRECTLY ONTO THE SCANNER GLASS. Excess liquid residue
may fog or damage the scanner.
•
Your scanner operates best in temperatures between 10
°
C to 40
°
C (50
°
F to 104
°
F).
Caution
Figure 7. Lamp Control
