6. After the software is installed, close all open applications and click on the [Finish]
button to restart your computer.
Attention
If the scanner installation is not started and displayed automatically
on the screen, click [Start], select [Run] and type in [d:\setup] (where
d: is the drive letter assigned to the CD-ROM drive of your
computer.)
Software Setup Troubleshooting
Carefully review the steps outlined in this guide and the Quick Installation Guide
that accompanied your scanner.
If you are still having problems, please check that:
•
You have 160MB of free space on your hard disk drive.
•
The scanner is plugged in and has power.
•
You are using the USB cable supplied with the scanner.
•
The square end of the USB cable is plugged into the rear of the scanner.
•
The rectangular end of the USB cable is plugged into the back of your
computer.
If you deviated from the installation procedures defined in this manual, please
unplug the USB cable from the scanner and reinstall the software from the CD-ROM.
To reinstall your scanner’s software, click [Start], [Run], then type [D:\Setup] (where
D represents the letter of your CD-ROM drive). Carefully follow all the installation
instructions presented in the Setup Wizard. Reboot your computer when prompted,
and plug the USB cable back into the scanner while your computer is still turned on.
Installing Additional Software
Your scanner is TWAIN compliant and functions with virtually all available
TWAIN compatible software. If you purchase additional software to be used with
your scanner, please make sure that it conforms to the TWAIN standard.
Scanner Setup After Windows XP Upgrade
If you plan to upgrade your operating system from Windows 98 or Me to
Windows XP after having installed the scanner software, please follow the
instructions below:
1. Unplug the scanner’s AC power adapter from the electrical outlet.
8
