Maintenance introduction
1
.
In order to maintain your treadmill, and prolong the life-span of it, we suggest that after 2 hours
operating, turn off the switch; continue to use after 10 minutes.
2
.
If the running belt is too loose, it will have slip during running; if it is too tight, that will reduce the
performance of motor, and increase the wear of roller and belt. When the degree of tightness
is suitable, you can use your hand to let both sides of belt from deck about
40 — 60mm.
Centring of running belt and the adjustment of the degree of tightness
In order to ensure the treadmill work better, you need to adjust the running belt to the best state.
Centring of running belt
:
·Put the treadmill on the flat floor;
·Make it operate with 3-6km/;
·If the running belt inclines to the right part, then let the right bolt rotate 1/2 round along the clockwise
direction, next let left bolt rotate 1/2 round along counter clockwise direction. Picture A
·If the running belt inclines to the left part,then let the left bolt rotate 1/2 round along the clockwise direction,
next let right bolt rotate 1/2 round along counter clockwise direction. Picture B.
Picture A
adjust to left part Picture
B
adjust to right part
The adjustment of the degree of tightness of poly V-belt
After running long time, the poly V-belt will loose due to wear and extrude,
You have to make suitable adjustment to ensure safety using. Method: during regular running, you can feel
occasionally pause when your feet on the deck, which indicate that running belt or poly V-belt has been
loosen, and you have to confirm. Methods to adjust which parts has been loosen: dismantle 5 slots of the
above protective cover, let the treadmill run at 1km/h, then stand on running belt, grip handles tightly, both
feet slightly hard to jam on the running belt.
(
We recommend that users use their body weight of pressing
power to jam on the running belt
)