No
Name
9
13
M12*40
8
No Name
Spec
quantity
13
14
15
screw
washer
ST4.2*12
12
4
4
M10*60
φ10.5*φ18*T1.0
16
17
bolt
bolt
M10*20
1
washer
1
φ10.5*φ20*T2.0
5
3
13
14
15
16 17
B
A
C
G
ST4.2*12
4
2
3
4
5
13
13
13
13
9
9
H G
1
I
J
Assemblage 3
1.Open right column group 3 and right armrest group 4 as
the figure showing, place part A and part C on
a proper position where will not affect assemblage.
2.Make connector wire G penetrate 5 through B as the
figure showing, and pull it out from outlet.
3. Pre lock 5 on
B
with 14, 15 by using 5mm Allen Wrench.
(Don't lock the screw)
4. Pre lock 5 on B with 16, 17 by using 6mm Allen Wrench,
and then lock the screw of 14,16 in sequence.
5. Lock A on B through 13 as the figure showing in
sequence as the figure showing by using cross
screwdriver and fasten.
6. Lock C on B through 13 as the figure showing in
sequence as the figure showing by using cross
screwdriver and fasten.
Attention
:
Do not pull wire heavily when plugging.
Assemblage 4
1. Pre lock left column group 2 and left armrest group 4 on 1
through 9 bu using 8mm Allen Wrench.
2. Lock I on 4 through 13 as the figure showing in sequence as the
figure showing by using cross screwdriver and fasten.
3. Link connector wire G of right column
and entire platform connector wire H,
and tuck the wire in outlet
to avoid affecting assemblage.
4. Pre lock right column group 3 and right
armrest group 5 on 1 through 9 by using
8mm Allen Wrench as the figure show.
5. Lock J on 5 through 13 as the figure
showing in sequence as the figure
showing by using cross screwdriver and
fasten.
Attention
:
Do not pull wire heavily when plugging.
bolt
screw
Spec
quantity