Mount screens to trolley / stand. Three persons are required for this step.
Note -
Two persons should lift each screen in to position whilst a third person supports the trolley until both screens are in position and secured.
9A -
Hook the TV tilt plate over the corresponding mounts on the sliding mount on the trolley-
Fig 9A
9B -
Insert
x2 (A) M8 washers
and
x2 (B) M8x12mm
to secure the TV tilt plate on to the sliding mount, tighten when screen is at the desired tilt angle -
Fig 9B
9C
-
Repeat above steps to install and secure the second screen.
Note -
Once both screens are secured in place they will counterbalance each other and the trolley will be safe to free stand unattended. Support trolley whilst making any
adjustments to the screens position.
Final steps
10A -
Ensure screens are secured in position and are equidistant from the centre point of the trolley before leaving the trolley unattended.
10B -
Check all fixings are secured and tightened appropriately.
10C -
Re-fit the top trims to your trolley or stand as per the instruction sheet for that product.
10D -
Once all cableing is installed you can fit the trim inserts in to the horizontal extrusion using the same method as stated in the instruction sheet for you trolley / stand.
Adjust screens.
Note -
Support the trolley / stand whilst adjustments are made.
9D -
To adjust a screens position on the horizontal extrusion loosen the x4 M8x12mm fixings and gently slide the screen along to the desired position, re-tighten fixings -
Fig 9D
9
10
Bx2
Ax2
Insert same fixings
in to the opposing
side also.
1
1
3
3
2
2
4
4
9D
9D
9A
9B
