Attach castors or feet to base unit.
The base comes preassembled with bonded aesthetic trim pieces - Do not remove!
1.1
Carefully turn the base upside down and attach x4 castor or x4 feet to all x4 corners as pictured
Castors - Fig 1.1
/
Glide Feet - Fig 1.2
1
Note:
All four uprights are preassembled with
joining plates
on one end (Do not remove). The uprights to be assembled with the cable gully facing inwards.
2.1
Turn the base over so it is the correct way up. Apply brakes to all castors. Do not stand on the base unit at any time.
2.2
Insert the open-end of the first 1200mm upright into the base and secure in place with
x3 ‘C’
per upright
- Fig 2.2
2.3
Repeat this process with the second 1200mm upright insuring the joining plates are at the top of each extrusion
- Fig 2.3
2.4
After both 1200mm uprights are firmly secured to the base unit add the 600mm uprights one at a time via the joining plates
- Fig 2.4
2.5
Fasten uprights together with
x2 ‘D’
the threaded holes are within the cable gully
- Fig 2.5
2
1200mm extrusion
1200mm extrusion
600mm extrusion
Cable gully
Joining plates
(DO NOT REMOVE)
Joining plate
at top
1.1
1.2
2.2
2.2
2.3
!
2.4
2.5
Cx6
Dx4
Ax16
Bx16
