Mount Screen
Note:
The TV and attached mounting arms will just hang on the trolley after being lifted into place but will also need a safety fixing installing to complete the installation.
Tilt adjustment of TV screen.
Two persons should be present to adjust the tilt angle of the screen on the trolley.
Do not apply any twisting forces to the screen, support the screen evenly across its width.
1.
The screen should be supported in its upright
position by an additional person until adjustment
is complete and all fixings re-tightened.
2.
Loosen the tilt adjustment allen bolts on both
mounting arms.
3.
Remove retaining bolt from the outside of
each mounting arm.
4.
Lower the tilt angle of the screen to desired
level and tighten one adjustment allen bolt
followed by the other making sure the angle of
both mounting arms is the same.
5.
Keep the retaining bolts in a safe place.
Trims and inserts.
Install any trim inserts into the uprights
before fitting the top trims.
Fit x2 trim pieces to top by hand
5
6A
6B
6C
6D
Note:
Additionally a padlock can be added to either or both TV mounting arms locking it to the TV mounting plate for added
security and theft deterrent. Each arm has two non-threaded holes specifically for attaching a padlock (not included).
Padlock locking tabs are located next to a the safety bolt fixing holes and need to be accessed from underneath the screen.
7
6
Tilt adjustment
allen bolt
Pozi drive
retaining screw
5.1
Position screen so the arms are at equal height to the mounting plate
- Fig5.1
5.2
Tip the upper edge of the screen towards the trolley to bring the ‘hook’ part on both mounting arms over the mounting plate
- Fig5.2
5.3
Lower the screen allowing the hooks to take the weight, carefully rest the screen back to vertical
- Fig5.3
5.4
Insert both safety fixings through the mounting plate and in to each mounting arm
- Fig5.4
5.1
5.2
5.3
5.4
Px2
Side view
