18
19
How to set up the compass:
1.
Be sure the radar detector is properly installed
in your preferred location – on the windshield,
the visor, or the dashboard of your vehicle.
2.
Press and hold the BACKLIGHT and MUTE buttons simultaneously for 3 seconds
until you
hear the radar detector beep once. The screen will display
“DRIVE IN A FULL CIRCLE… PRESS
ANY BUTTON WHEN DONE”
. You will have one minute to complete the maneuver.
3.
Drive your vehicle in a full 360o circle.
The size of the circle and direction of your vehicle do
not matter. The circle does not need to be perfectly round but must be completed going in the
same direction.
4.
Press any button to complete the compass set-up.
The radar detector will beep twice and
display
“SET-UP COMPLETE”
if the set-up was successful.
If there was an error during set-up,
the radar detector will display
“SET-UP INCOMPLETE… PRESS
MUTE TO RESTART SET-UP… PRESS BACKLIGHT TO CANCEL SET-UP”
.
•
Press the MUTE button to restart the set-up.
The radar detector will display
“DRIVE IN A FULL
CIRCLE… PRESS ANY BUTTON WHEN DONE”
. Try again to drive your vehicle in a full 360 o
circle, then press any button to complete the set-up.
•
Press the BACKLIGHT button to cancel the set-up.
The radar detector will display
“SET-UP
CANCELLED”
and exit from the compass set-up process. The radar detector may indicate
inaccurate directions until the compass set-up is successfully completed.
•
When none of the buttons are pressed
during the warning signal, the radar detector will display
“SET-UP CANCELLED”
and exit from the compass set-up process.
The radar detector will ignore any signal threats during the compass set-up process.
OPERATION DETAILS
Summary of Contents for SENSORO SILVER BULLET RX7600
Page 30: ...NOTES...