11
Calibrating the compass (hand mode)
Place the Wayfinder V700 on its back (face
up) on a flat surface. Avoid magnetic surfaces
such as steel tables.
Hold the “CAL ” button. The display will
show “
Hold to CAL
.” After 2 seconds the
display will flash all segments of the rose
and the message “
Press CAL
” will appear.
This is asking for confirmation to start the
calibration process. Pressing the “On/Off
” button or changing the mode (by changing
angle by more than 45°) at this stage will
cancel calibration, and the compass will
revert to normal mode.
Press the “CAL ” button briefly. “
TURN
”
will appear beneath the top arrow element
and “
Press CAL when done
” will appear in
the center of the display. Rotate the compass
in a single 360° circle. The direction of the
circle does not matter, but the whole process
should take 15 to 30 seconds. Press “CAL
” again and the compass will display “
CAL
done
” for 2 seconds before reverting to the
standard directional display. You have now
calibrated your compass for hand mode.
You can safely replace the Wayfinder V700 in
its holding bracket. In the vertical position it
will remember its vehicle calibration details.
CALIBRATION