Enclosure Installation
This section explains how to mount the machine into the enclosure. This can be a bit tedious,
but you only need to do it once as the machine will stay mounted inside the enclosure.
Materials Needed:
-
(5) M4x6 screws*
-
(5) rubber bumpers (optional)*
-
Pocket NC V2 Enclosure
-
Pocket NC V2 Mill
*Included in enclosure hardware kit
Tools Needed
-
3 mm hex driver or hex key
1) Remove the 5 feet from the machine (where the red arrows point to in the photo above
left).
2) Place the machine on the shelf inside the enclosure.
6
