28
PROBLEM
CAUSE
SOLUTION
The compressor
does not work
Uncharged battery
Charge the battery
Failed battery
Contact your after-sales service to replace the battery
12 V DC adapter not connected
Connect the 12V DC adapter correctly
Cigarette lighter socket not powered
Check vehicle fuse
Main switch to OFF
Set the main switch to ON
Other causes
Contact your service center
Compressor starts
and stops instantly
The mains charger is connected
and the battery is not yet
sufficiently charged (red light on)
Unplug the charger or wait until charging is complete.
Valve closed
Open the tyre valve
Connector incorrectly plugged in
Check the position of the connector
Pinched or plugged hose
Check the hose - have it changed if necessary.
The battery does not
charge
The charger is faulty (red light off)
Contact your service center
Failed battery
Contact your service representative to replace the
battery
Main switch to OFF
Set the main switch to ON
Battery does not hold
charge
Failed battery
Contact your after-sales service to replace the battery
The compressor does
not reach the desired
power
Uncharged battery
Charge the battery or switch to 12 V mode by
plugging the compressor into the 12 V DC socket on
the cigarette lighter
Air leak
Inspect the hose. Have it changed if necessary
Bad tip connection. Tighten or replace the inflation tip
Check the seals of the tips and accessories
Check the tightness of the tips and accessories
The compressor
heats up
Intensive use
Let the compressor sit for at least 20 minutes
PROBLEM RESOLUTION - TROUBLESHOOTING GUIDE
IMPORTANT: imperatively put the switch
2
on OFF position
before performing any cleaning or maintenance operation .
• Clean your compressor regularly with a damp cloth . Do not use
abrasive or solvent
• The screen of the LCD display should be cleaned carefully to
avoid scratches and bumps .
• The ventilation openings must be cleaned regularly with a
brush or a dry cloth, avoiding introducing objects inside the
compressor .
• The compressor must be carried in its pouch to avoid the risk of
shocks during transport or storage .
• The compressor must not be dismantled . In case of disassembly
for a compelling reason, be sure to tighten the screws
moderately during reassembly .
MAINTENANCE AND SERVICE
Repair of this machine should only be carried out by a qualified and approved manufacturer.
Contact your after-sales service (mentioning the make, model and serial number).
EN TROUBLESHOOTING AND SERVICE GUIDE
Summary of Contents for 900180
